Temperature Calibrator (HGETX-1810)

Function
1. It allows you to measure DC V, DC mV, resistance, TC and RTD.
2. Outputs resistance, simulation of TC and RTD.
3. Automatic and manual cold end temperature compensation for TC.
4. Manual stepping, automatic stepping, 0~100% phase step and ramp output.
5. Super-strong protection: The waterproof grade is IP67. Automatic protection against the signal terminals connect to the 220V.

Factory Reset
Factory reset consists of the following items:
1. The working status recovers to the voltage measurement.
2. Automatic shutdown time is reset to be 30 min, which is effective.
3. LCD backlight brightness is set to be 60%.
4. Output span is recovered to be factory default.
5. Start the calibrator and press until the buzzer works, and the recovery of factory default will enter working mode when the recovery is completed.

Power

The calibrator needs 6 disposable LR03 model (size 7) alkaline batteries or 6 R03 model (size 7) nickel-metal hydride batteries (or nickel-cadmium batteries). The longest service life of alkaline batteries can reach 50 hours.
A 12V/1A power adaptor is used for charging and providing working power for the calibrator.

Standard Accessories
A set of HGETX-2010/HGETX-1810 calibrator also includes the following items:
1. Hard spot test leads (one set)
2. Alligator clip (one set)
3. One 12V/1A power adaptor
4. HGETX-2010/HGETX-1810 users manual

Warning
To avoid possible electric shock or personal injury:
1. Test a given voltage to confirm its normal operation before using.
2. Please follow all the safety operation standards.
3. Select correct function and range gear according to measurement requirements.
4. Confirm the closing of battery door before calibrator application.
5. Remove the test line of calibrator before opening the battery door.
6. Check whether damaged or exposed metal exists in the test line and whether the test line has been conducted. Replace the damaged test line before using.
7. Fingers should not touch the metal contact when the detector is used. Fingers should be behind the finger-protecting device.
8. Connect the common line and then electric test line. As for wire removal, electric test line should be first removed.
9. Don't use the calibrator in case of abnormal operation. Calibrator should be repaired because it may have been damaged.
10. Don't ues the calibrator near explosive gases.
11. Remove the test line before changing measurement or output function.
12.6 LR03 (7 size) alkaline batteries or R03 nickel-metal hydride batteries (or nickel-cadmium batteries) should be used in the calibrator and the battery should be placed inside the meter housing.
13. Replace or charge the battery when the screen displays low pressure of battery, to avoid reading error and possible electric shock or personal injury.